Pit Posse Table Bracket

While it is not a tragic mistake, I ordered these and the logo plate and USA decal is misplaced to the inside of the bracket mounts. Seems someone was not paying attention during assembly. Also the two little posts that hold the Pit Posse bracket on was extremely loose, so I had to use a hammer to join the post to the bracket and logo plate. I’m afraid that the logo plate being on the inside of the brackets may rub a damage spot into the plastic over time. They are also only 3” inside dimensions from the wall when you mount them, not 5” like all descriptions say.

Stickers were on inside of brackets and no mounting hardware was included.

This wasn't big enough to fit a pretty standard 6' folding table that splits in half to fold up. Brackets were about half as deep as needed.

So...first of all, these simple little units appear to be of fine quality, are pre-drilled and come with screws. And they have "Made in USA" stickers on them. Super easy to install. Not that it could have been hard. The issue though is that they are WAY deeper/taller than they need to be. The stated function is to hold a plastic folding table. But these things are nearly deep enough to put two such tables in there. Not quite...you for sure wouldn't get a 2nd one in there - but there's so much of a gap once a table is in there that it'd just slam around as you were driving - and also they needlessly stick out an additional 1.5" or so more than they need to from the wall, making it that much more likely you bang a knee on them or something. I used some foam from a shipping box I had laying around to cut some pieces out to stick in there so that my table wouldn't just flop around. So...it works. I just can't for the life of me figure out why they would have thought they needed to have like an extra 1.5" of useless space there. Makes no sense.